Valcom Speaker V 1060A User Manual

Issue 9  
45 OHM TALKBACK INTERIOR SPEAKERS  
`
V-1060A  
V-1060B  
V-1061-W, V-1061-BK  
V-1062A, V-1064A. V-1066A  
V-1063A, V-1065A, V-1067A  
INTRODUCTION  
Dimensions/Weight  
These instructions contain the specifications and  
guidelines necessary to install, operate and maintain  
Valcom 45 Ohm Talkback Interior Speaker  
Assemblies.  
8” Ceiling Speakers:  
V-1060A talkback speaker  
V-1060B talkback speaker with LED  
13.00" Diameter x 2.50" D  
(33.02cm Diameter x 6.35cm D)  
2.5 lbs. (1.13 kg)  
Wall Speakers:  
The 45 Ohm Talkback Interior Speaker Assemblies  
are for use with the Valcom "handsfree" talkback  
page control units and are for interior use only.  
V-1061-BK black vinyl w/black cloth grille  
V-1061-W white vinyl w/white cloth grille  
9.60" H x 11.50" W x 4.20" D  
(24.38cm H x 29.21cm W x 10.67cm D)  
4 lbs. (1.81 kg)  
V-1062A wood grain w/light brown open weave grille  
V-1063A wood grain w/dark brown cloth grille  
10.60" H x 9.70" W x 5.20" D  
(26.92cm H x 24.64cm W x 13.21cm D)  
4.0 lbs. (1.81 kg)  
SPECIFICATIONS  
Features  
45 Ohm Impedance  
8 Inch Speaker  
Easy Hook-up (2 connections using house cable  
or station wire)  
LED indicator (V-1060B only)  
1
947065  
 
CORNER SPEAKERS: After making the  
required connections to the speaker, use  
appropriate hardware such as an 8d finishing  
nail and hang the speaker in the corner. Typical  
mounting height would be 8 feet.  
INSTALLATION  
Connections  
Two conductor (four conductor for V-1060B  
only) twisted wire is required for the 45 Ohm  
talkback speakers. Standard 22 or 24 gauge  
station wire is acceptable. Shielded wire is not  
required or recommended.  
CORRIDOR SPEAKERS: Unscrew mounting  
bracket and baffle from speaker assembly.  
Using appropriate hardware, mount the bracket  
to the wall. After making the required  
connections, reattach the baffle to the speaker  
and the speaker to the mounting bracket.  
Connections are as follows:  
Speaker out from page control to speaker tip  
Speaker common to speaker ring  
For 1060B only:  
Switched -24VDC to -24VDC (LED)  
Power Supply ground to GND (LED)  
TECHNICAL ASSISTANCE  
When trouble is reported, verify there are no  
broken connections. Troubleshooting  
assistance is available from the factory.  
Call (540) 563-2000 and press 1 for Technical  
Support, or visit our website at  
Mounting  
CEILING SPEAKERS: Cut an 8.5" diameter  
hole in ceiling tile. After connections have been  
made to the speaker, attach speaker to ceiling  
tile using the mounting hardware provided.  
NOTE: Where extra speaker support is needed,  
a V-9916 or V-9916M Valcom Bridge and  
Backbox should be used.  
Valcom equipment is not field repairable.  
Valcom, Inc. maintains service facilities in  
Roanoke, VA. Should repairs be necessary,  
attach a tag to the unit clearly stating company  
name, address, phone number, contact person  
WALL SPEAKERS: After making the required  
connections, fasten a suitable mounting screw  
(#10 sheet metal screw or similar) to the wall at  
the desired location for mounting of the speaker.  
Hang the speaker on the screw using the  
keyhole on the speaker bracket.  
and the nature of the problem. Send the unit to:  
Valcom, Inc.  
Repair and Return Dept.  
5614 Hollins Road  
Roanoke, VA 24019-5056  
TROUBLESHOOTING CHART  
SYMPTOMS  
ACTIONS  
No sound in page mode  
Check tip and ring for audio at speaker.  
Check tip and ring for audio at control unit.  
Check volume controls at page control.  
Low sound in page mode  
Poor listening in talkback mode  
Check talkback volume control at page control. Set control where audio is  
clearly audible.  
No LED indication (on V-1060B)  
Check presence and polarity of LED input signal.  
VALCOM LIMITED WARRANTY  
Valcom, Inc. warrants its products to be free from defects in materials and workmanship under conditions of normal use and service for a period of one  
year from the date of shipment. The obligation under this warranty shall be limited to the replacement, repair or refund of any such defective device  
within the warranty period, provided that:  
1.  
2.  
3.  
inspection by Valcom, Inc. indicates the validity of the claim;  
the defect is not the result of damage, misuse or negligence after the original shipment;  
the product has not been altered in any way or repaired by others and that factory sealed units are unopened (A service charge plus parts  
and labor will be applied to units defaced or physically damaged);  
4.  
5.  
freight charges for the return of products to Valcom are prepaid;  
all units ‘out of warranty’ are subject to a service charge. The service charge will cover minor repairs (Major repairs will be subject to  
additional charges for parts and labor).  
This warranty is in lieu of and excludes all other warranties, expressed or implied, and in no event shall Valcom, Inc. be liable for any  
anticipated profits, consequential damages, loss of time or other losses incurred by the buyer in connection with the purchase, operation or  
use of the product.  
This warranty specifically excludes damage incurred in shipment. In the event a product is received in damaged condition, the carrier should be notified  
immediately. Claims for such damage should be filed with the carrier involved in accordance with the F.O.B. point.  
Headquarters:  
Valcom, Inc.  
5614 Hollins Road  
Roanoke, VA 24019-5056  
Phone: (540) 563-2000  
FAX: (540) 362-9800  
3
 

Tech Craft TV Video Accessories BCE72 User Manual
Texas Instruments Projector DU9000 User Manual
Toshiba Surge Protector TVS XT120 347 User Manual
TP Link Network Card TL PA2030 User Manual
TRENDnet Switch TK400K User Manual
Uniden Cordless Telephone D2280 User Manual
Vector Automobile Battery Charger VEC1089ABD User Manual
Viper Musical Instrument Amplifier MF 105B User Manual
VTech Battery Charger LS6325 User Manual
Vulcan Hart Electric Steamer VSX10GC User Manual